CCS Concrete Stains
Suggested Specfication for CCS Rembrandt Stain System -
Application On Existing Concrete
Ensure the concrete is structurally sound, any cracks have been repaired and that all coatings, adhesives and friable matter have been removed from the surface. Prime surface with a dilution of CCS Super Polymer and water.
Mix CCS Resurfacing Compound and CCS Super Polymer at a rate of 2.5 litres toa 20kg bag plus 2.5 litres of water and apply mixture to surface. Immediately trowel with a 3-5mm notched trowel to create a consistent finish with no coldjoints. Trowel finish to desired smoothness.
After the resurfacing compound has cured for 24 hours, apply up to two coats of Concrete Colour Systems (nominate stain colour eg. Aztec Red or refer to Rembrandt brochure for list of diluted colours) Rembrandt Stain at a rate of 1 litre per 8 square metres to duplicate previously approved on-site samples. Apply with a brush, squeegee sponge or spray gun.
Where second or third colours are used:- After four hours another secondary colour can be applied. Apply one coat of Concrete Colour Systems (nominate stain colour or refer to Rembrandt brochure for list of diluted colours) at a rate of 1 litre per 8 square metres.
(Optional) Saw cut or scribe designs into the surface as per attached drawing. When the surface is clean and dry, seal with two coats of CCS Hardseal Advanced or CCS Armourthane (nominate one of these sealers) ensuring that the existing surface is slip safenor if not, add sufficient anti slip media, such as CCS Sealer Grip, to the sealer to create a safer surface.